Salt resisting stainless steel marine residential reverse osmosis systems multistage pump
Product Description
Salt resisting stainless steel marine residential reverse osmosis systems Multistage Pump
For this series horizontal multistage centrifugal high pressure residential reverse osmosis systems multistage pump , both ends of it are supported, the casing portion is in a sectional form. it is connected to and actuated by a motor via a resilient clutch and the rotating direction of it. viewing from the actuating end. is clockwise. Refer to Fig. I for the structure of it.
Stator portion
high pressure Water Pump consists of suck-in section. middle-section, spitting section, guide vane, packing etc., which are linked together with a take-up bolt. with both suck-in and spitting mouths vertically upward.
Rotor portion
Consists of a shaft, impeller, balancing disk, muff etc. Parts.
Bearing portion
The whole rotor is supported by the roller bearings or sliding bearings on both ends of the shaft and the bearings are lubricated with grease or 20# engin oil.
Cooling and seal of residential reverse osmosis systems multistage pump
The joint-part between suction section, intermediate section and discharge section with be coated with molybdenum disulfide lubricating grease as seal. Rotor and fixed parts will be sealed by seal ring, guide-vane jacket and packing. The packing tensile degree of shaft seal should be proper and seep should be feasible dip by dip Unload run should be forbid. The seal ring and guide vane jacket should be replaced if they are too worn to be used any more and even do harm to pump work. There is spare shaft sleeve near shaft seal to protect shaft of pump.
Construction of residential reverse osmosis systems multistage pump
Sand Gravel Pump | Horizontal Slurry Pump | Vertical pipe pump |
Pipe System | Vertical Sump Pump | Submersible Pump |
Contact AN PUMP
Product Categories : Water Pump > QD Horizontal Multistage Pump
Premium Related Products